Being able to stop safely is as important as accelerating, perhaps more so. The braking system multiplies a small force on the pedal using hydraulic pressure and transmits it to the wheels. Through friction the car’s energy of motion is turned into heat and the car slows down. Knowing the parts of this system and its warning signs matters for your safety and for avoiding unnecessary costs.
How does the brake system work?
When you press the brake pedal, a cylinder called the master cylinder pressurises the brake fluid in the lines. Because liquids cannot be compressed, the pressure is transmitted directly to the brake mechanisms at the wheels. The brake booster found on most cars uses vacuum from the engine to increase pedal force, which is why the pedal becomes very hard when the engine is off.
Disc and drum brakes
In disc brakes, pads inside a caliper squeeze a metal disc that turns with the wheel from both sides. Because they dissipate heat well and recover faster when wet, they are almost standard on the front wheels; as weight shifts forward under braking, the front brakes do most of the work. In drum brakes, brake shoes press against the inside of a rotating drum. Being cheaper and compatible with the handbrake, they are still used on the rear wheels of some cars.
Pad and disc wear
Pads wear a little with every stop. Their life varies greatly with driving style, vehicle weight and conditions; stop-start city traffic uses up pads much faster than motorway driving. Many pads have a metal wear indicator that rubs on the disc with a high-pitched squeal when they reach their limit, or a sensor that lights a warning on the dashboard. When pads are completely worn, metal grinds against metal, lengthening stopping distances and damaging the disc. Discs also thin over time and are replaced when they fall below the minimum thickness set by the manufacturer.
Why change brake fluid?
Brake fluid absorbs moisture from the air over time. As its water content rises, its boiling point falls; under heavy braking, such as a long descent, the fluid can heat up and form vapour bubbles. The pedal then sinks and braking power drops. That is why many manufacturers recommend changing brake fluid usually every two years; check the vehicle’s service manual for the exact interval. A sudden drop in fluid level may indicate a leak.
ABS and other assistance systems
The anti-lock braking system (ABS) adjusts brake pressure many times a second during hard braking to stop the wheels locking and skidding, so the driver keeps steering control while braking. Feeling vibration and hearing noise through the pedal when ABS is working is normal; keep pressing without releasing the pedal. Modern cars also have electronic stability control (ESC) and emergency brake assist in addition to ABS.
Signs that mean a trip to the garage
- Squealing, grinding or metallic scraping noises when braking
- A pedal that feels softer than normal, sinks low or feels spongy
- The car pulling to one side when braking
- Vibration through the steering wheel or pedal
- A brake or ABS warning light on the dashboard
- A burning smell or excessive heat around a wheel
This article is for general information. Brake repairs require expertise; have the car checked by an authorised garage if you notice any suspicious sign.
Frequently asked questions
Is there anything to watch out for after fitting new pads?
It is generally recommended to avoid sudden, very hard braking for the first few hundred kilometres so that new pads bed in fully with the disc. Details are given in the manufacturer’s instructions.
Sources and further reading
- U.S. National Highway Traffic Safety Administration (NHTSA), “Antilock Brakes” and vehicle maintenance guides.
- Bosch, Automotive Handbook (latest edition), braking systems chapter.
- Vehicle manufacturers’ service manuals (brake fluid change intervals).
Leave a comment
Your email address will not be published. Required fields are marked *